We start by pumping out any standing water, then move straight into liner installation and humidity control.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
We follow manufacturer specs on liner overlap and seam tape so the barrier actually holds up over time.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
No hourly billing — the number we quote is the number on the final invoice.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
Every Burnsville, MN Crawl Space Encapsulation job starts with an inspection, not a generic package — here's what that typically includes.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
A crawl space needs its own sump basin and discharge line separate from any basement system, since the two spaces drain differently.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
We take humidity and moisture readings to establish a baseline before recommending a system.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Burnsville Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Burnsville Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— Burnsville Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Burnsville Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
We'll recommend a thickness based on how the space is actually used, not just a default.
In most Burnsville, MN climates, yes — open vents pull in humid air that undoes a lot of the benefit of the liner alone.
Often yes, if the crawl space is the source — sealing and dehumidifying typically resolves musty odors within a few days of installation.
Standing water doesn't disqualify a space from encapsulation; it's just the first step in the process.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
We encapsulate crawl spaces throughout Burnsville and the surrounding Burnsville, MN service area, including the zip codes listed below.
Zip codes we serve in Burnsville, MN: 55306 55337
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
